![]() ![]() I have enjoyed providing Window Cleaning & Exterior House Cleaning Services too many satisfied customers in all areas of the Gold Coast since 1995. When using Crystal Clear Windows for your cleaning, you will receive a quality, efficient and affordable service you can trust. I am fully Insured with 10 Million Public Liability and hold a Current Queensland Police Check. Guy Waldron owner operator of Crystal Clear WindowsĠ755 331 222 or 0412 222 393 Window Cleaning Gold Coast and Hinterland for 20 YearsĪs an experienced Owner and Operator of a trusted Gold Coast local business, I can assure you that all Window Cleaning will be completed thoroughly to the highest standard with no mess to tidy up. Prompt, Reliable and Affordable Window Cleaning Crystal Clear Windows! ![]() Before using, user shall determine the suitability of this product for his/her intended use and the user assumes all risk and liability whatsoever in connection therewith.Window Cleaning Gold Coast Window Cleaning on the Gold Coast for 20 Years Manufacturer and sellers are not responsible or liable for injuries, damaged equipment, direct or otherwise, due to incorrect use of this product. NOTICE: Manufacturer and sellers will only replace product which is defective. Always wash hands and contaminated skin after using, paying particular attention to skin under nails. Do not rub in with fingers or permit contact with skin or eyes. NOTE: If glass becomes hazed or white, proceed no further until you can determine if it is a coating, building sealer or Stage II corrosion, or if given permission by supervision or building management personnel.Ĭontains Acid: CAS. DO NOT USE ON SELF-CLEANING (TITANIUM) GLASS. Repeat as necessary.ĭO NOT USE CRYSTAL CLEAR-550 ON WINDOW FRAMES OR ANY NON-GLASS SURFACE. Apply for one to two minutes, then rinse with water or a dilute solution of trisodium phosphate. If product runs down the glass, it is being overused. Keep solution from running down any building or other surfaces. (GLASS WILL USUALLY TURN WHITE WITH COATINGS AND STAGE II CORROSION WHEN TESTED.) STAGE II CORROSION IS NOT CORRECTABLE AND GLASS SHOULD BE REPLACED.Īpply CRYSTAL CLEAR-550 with a natural sponge or a clean, white cloth. (According to some glass manufacturers, silicone treatments and building sealers may be removed by applying toluene first to soften the film and a low abrasive rubbing compound to remove the residue.)ĬHECK BOTH SIDES OF GLASS FOR STAGE II CORROSION. CRYSTAL CLEAR-550 is NOT a cleaner.ĪLWAYS TEST GLASS BEFORE APPLYING CRYSTAL CLEAR-550 TO ENTIRE WINDOW.Ĭheck for surface coatings and residues such as silicone treatment, building sealer and waxes. Do not use metal or painted containers.Ĭlean window glass before using CRYSTAL CLEAR-550. AVOID CONTACT WITH SKIN.Īlways use plastic pails and containers. ALWAYS WEAR RUBBER GLOVES, PROTECTIVE CLOTHING, BOOTS AND SPLASH GOGGLES. USE STRAIGHT OR DILUTED BY 50% WITH COOL WATER. “Smears go away while surface is wet and reappear as soon as it is dry again” – generally this is an indication that the glass is in stage II corrosion. If the pre-existing damage is substantial then mechanical polishing or glass replacement may be necessary. That is why the product label and literature expresses to test every window before clearing. ![]() Stage II corrosion is usually not correctable using compounds such as CRYSTAL CLEAR 550 and can be made worse by any attempt to clear. This refracted light appears to the human eye, without magnification, as a general whitening or haziness of the glass.ĬRYSTAL CLEAR 550 will clear away only mineral deposits and damaged glass from the surface and may expose stage II corrosion. Cloudiness occurs because the light is refracted irregularly as it passes through the irregular surface of the damaged glass. Stage II corrosion may look hazy, white or even in some cases clear, as it holds on to the damaged particles until they are released by cleaning or clearing the glass. Stage I corrosion can be cleared so that visibility is restored to the glass. This is known as stage I and stage II corrosion. Overtime these surface deposits and etching of the glass can be perceived as cloudiness or hazing. Such deposits damage glass and do not readily come off with just regular washing. Part of the visible haze may be mineral deposits, structure runoff, pollution in the air or other contaminates, which attach tenaciously to the glass. It is not until the window is washed and the haze remains, that the damage is noticed. Much of what happens to glass is so gradual that one does not often see anything wrong with the window.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |